Hey Ya Hozers,
Last week after getting the Kabul Kab Service out of hibernation,
Took it out for a ride to get fresh gas.
I was hearing a growl, low pitched whining.
Thinking it could be a Differential Gear noise,
My drive shaft yoke at the pinion bearing,
You can move it ever slightly up and down.
I know Ural's don't have Exact Tolerances,
But am I in for a Final Drive Rebuild?
Final Drive yoke input play ?
Forum rules
This is the place for general discussion about motorcycles and life in general. No political posts. Use The "Other" Toy Box section for other bikes, guns, collectibles or hobbies.
This is the place for general discussion about motorcycles and life in general. No political posts. Use The "Other" Toy Box section for other bikes, guns, collectibles or hobbies.
-
DisplacedYooper
- Comrade
- Posts: 82
- Joined: Sun Jun 24, 2018 9:08 am
-
Tomcatfixer
- Commissar
- Posts: 12075
- Joined: Sat Oct 24, 2015 5:10 am
- Location: Gordonsville, VA
Re: Final Drive yoke input play ?
Most likely. None of mine have ever experienced play like that.
- Chad
Gordonsville, Virginia, USA
Current rides:
2015 cT "Mobile Chernobyl", 2003 Retro Solo, 2001 Patrol "Little Red Bear", 1999 Tourist "The RPOC", 1994 Honda VFR750F, 2007 BMW K1200GT
Previous rides:
2007 Honda VTR1000 FireStorm (Super Hawk in U.S.)
2001 Buell Blast! - - - - - - - 2005 Yamaha FJR1300
1993 Honda CBR600F2 - 1984 Yamaha FJ1100
Two 1986 Yamaha FZX700S Fazers
1997 Deco Classic
1998 Tourist "The Heap"
Gordonsville, Virginia, USA
Current rides:
2015 cT "Mobile Chernobyl", 2003 Retro Solo, 2001 Patrol "Little Red Bear", 1999 Tourist "The RPOC", 1994 Honda VFR750F, 2007 BMW K1200GT
Previous rides:
2007 Honda VTR1000 FireStorm (Super Hawk in U.S.)
2001 Buell Blast! - - - - - - - 2005 Yamaha FJR1300
1993 Honda CBR600F2 - 1984 Yamaha FJ1100
Two 1986 Yamaha FZX700S Fazers
1997 Deco Classic
1998 Tourist "The Heap"
-
phughes
- Hero of the Soviet Union 2022
- Posts: 1617
- Joined: Sun Jul 12, 2015 10:44 pm
- Location: Pittsburgh area
Re: Final Drive yoke input play ?
It is fairly easy to remove the yoke, then pull the pinion gear and bearing. Keep the input end of the final drive pointed up and you won't even disturb the loose bearings on the small end of the pinion. I had mine out the other day. You could get lucky and it may only be the outer bearing.DisplacedYooper wrote: ↑Sat May 27, 2023 7:46 amHey Ya Hozers,
Last week after getting the Kabul Kab Service out of hibernation,
Took it out for a ride to get fresh gas.
I was hearing a growl, low pitched whining.
Thinking it could be a Differential Gear noise,
My drive shaft yoke at the pinion bearing,
You can move it ever slightly up and down.
I know Ural's don't have Exact Tolerances,
But am I in for a Final Drive Rebuild?
Phil
-------------------------------------------
2014 Gear Up
2009 Kawasaki Concours
Schwinn 24 inch Unicycle
-------------------------------------------
2014 Gear Up
2009 Kawasaki Concours
Schwinn 24 inch Unicycle
-
DisplacedYooper
- Comrade
- Posts: 82
- Joined: Sun Jun 24, 2018 9:08 am
Re: Final Drive yoke input play ?
Thank You,
I did buy a Spare Final Drive two years ago
Off a Wrecked bike.
So I do a swap, and rebuild this one.
Just another day in the shop instead of out riding.
I did buy a Spare Final Drive two years ago
Off a Wrecked bike.
So I do a swap, and rebuild this one.
Just another day in the shop instead of out riding.